Table of Contents
Advertisement
NOTE
All chips must be removed from the tapped
hole prior to insert installation.
7. Using compressed air, clean out any chips.
NOTE
Do not allow oil or other foreign material to
contact the outside diameter (OD) of the
insert.
8. Lubricate the threads of the driver installation tool (2)
with the J 42385-110 (1).
9. Install the insert (2) onto the driver installation tool
(1).
10. Apply threadlock sealant GM P/N 12345493,
(Canadian P/N 10953488), J 42385-109, LOCTITE
277® or equivalent (1) to the insert OD threads (2).
Engine Mechanical:
1D-233
Advertisement
Table of Contents
Troubleshooting
