Suzuki XL7 2007 Service Manual page 658

1D-318 Engine Mechanical:
9. Tighten the engine front cover bolts in the sequence
shown (1-22).
Tightening torque
Tighten the engine front cover bolts in the
sequence to 23 N⋅m (17 lb ft).
10. Place the camshaft position actuator valves in
position on the front cover.
11. Install the camshaft position actuator valve bolts.
Tightening torque
Tighten the camshaft position actuator valve
bolts to 10 N⋅m (89 lb in).
12. Install NEW O-rings on the camshaft position sensor.
13. Place the camshaft position sensors in position on
the front cover.
14. Install the camshaft position sensor bolts.
Tightening torque
Tighten the camshaft position sensor bolts to 10
N⋅m (89 lb in).
Reference: "Water Pump Installation: ".
Engine Front Cover Installation (Fourth
Design)
Reference: "Engine Front Cover Assemble: ".
Special tool
EN 46109 Guide Pins
1. Install the 8 mm (0.315 in) guide from the EN 46109
into the cylinder block positions as shown.