Suzuki XL7 2007 Service Manual page 469

29. Connect the steering intermediate shaft to the
steering gear.
30. Install a NEW pinch bolt to the steering intermediate
shaft.
Tightening torque
Tighten the bolt to 34 N⋅m (25 lb ft).
31. Install the right and left engine splash shields. Refer
to "Engine Splash Shield Replacement - Left Side: "
and "Engine Splash Shield Replacement - Right
Side: ".
32. Install the front tires. Refer to "Tire and Wheel
Removal and Installation: ".
33. Install the catalytic converters. Refer to "Catalytic
Converter Replacement - Left Side: " and "Catalytic
Converter Replacement - Right Side: ".
34. Install new seals and connect the transaxle oil cooler
lines to the transaxle. Refer to "Fluid Cooler Pipe
Seal Replacement: ".
35. Install the radiator outlet hose. Refer to "Radiator
Outlet Hose Replacement: ".
36. Lower the vehicle.
37. Install the radiator inlet hose. Refer to "Radiator Inlet
Hose Replacement: ".
38. Connect the heater hoses to the engine. Refer to
"Heater Outlet Hose Replacement: ".
39. Untie the radiator, AC condenser, and fan module
assembly from the upper radiator support.
40. Connect the transaxle shift control cable to the
transaxle. Refer to "Shift Control Cable
Replacement: ".
41. Install the AC compressor hose assembly to the
compressor. Refer to "Compressor Hose Assembly
Replacement: ".
42. Connect the engine fuel hose/pipe (3) to the chassis
fuel hose/pipe (2). Refer to "Metal Collar Quick
Connect Fitting Service: ".
43. Connect the EVAP hose/pipe to the EVAP canister
purge solenoid valve. Refer to "Plastic Collar Quick
Connect Fitting Service: ".
44. Install the air cleaner assembly. Refer to "Air Cleaner
Assembly Replacement".
Engine Mechanical: 1D-129