Suzuki XL7 2007 Service Manual page 842

1G-42 Fuel System:
5. Connect the left rear brake line fitting to the brake
crossover pipe.
Tightening torque
Tighten the fitting to 18 N⋅m (13 lb ft).
6. Remove the caps from the fuel and EVAP lines.
7. Connect the fuel feed pipe quick connect fitting (2) to
the fuel tank. Refer to "Plastic Collar Quick Connect
Fitting Service".
8. Install the EVAP canister. Refer to "Evaporative
Emission Canister Replacement: ".
9. Lower the vehicle.
10. Connect the rear brake line fittings to the brake
pressure module.
Tightening torque
Tighten the fitting to 21 N⋅m (16 lb ft).
11. Remove the caps from the fuel and EVAP lines.
12. Connect the fuel feed pipe quick connect fitting (3) to
the fuel rail. Refer to "Metal Collar Quick Connect
Fitting Service".
13. Connect the EVAP pipe quick connect fitting (3) to
the EVAP purge solenoid. Refer to "Plastic Collar
Quick Connect Fitting Service".
14. Connect the negative battery cable. Refer to "Battery
Negative Cable Disconnection and Connection: ".
15. Bleed the hydraulic brake system. Refer to
"Hydraulic Brake System Bleeding (Pressure): "
"Hydraulic Brake System Bleeding (Manual): ".