Suzuki XL7 2007 Service Manual page 671

4. Place the crankshaft balancer in position on the
crankshaft.
5. Thread the J 41998-B in the crankshaft. Ensure you
engage at least 10 threads of the J 41998-B before
pressing the crankshaft balancer in place.
6. Push the crankshaft balancer into position by
tightening the nut on the J 41998-B until the large
washer bottoms out on the crankshaft end.
7. Remove the J 41998-B.
8. Install the crankshaft balancer bolt.
CAUTION
!
Refer to "Fastener Notice: ".
9. Tighten the crankshaft balancer bolt.
Tightening torque
1. Tighten the crankshaft balancer bolt to 100
N⋅m (74 lb ft).
2. Tighten the crankshaft balancer bolt an
additional 150 degrees using the J 45059.
10. Remove the EN 46106.
Reference: "Oil Filter Adapter Installation: ".
Drive Belt Tensioner Installation
1. Place the left drive belt tensioner assembly in
position to the engine front cover.
CAUTION
!
Refer to "Fastener Notice: ".
2. Install the left drive belt tensioner bracket bolts.
Tightening torque
Tighten the left drive belt tensioner bracket bolts
to 23 N⋅m (17 lb ft).
Engine Mechanical: 1D-331