CAUTION
!
Refer to "Fastener Notice: ".
6. Install the crankshaft rear oil seal housing bolts.
Tightening torque
Tighten the crankshaft rear oil seal housing bolts
to 10 N⋅m (89 lb in).
7. Remove the EN-47839 and J 42183 (1, 2) from the
crankshaft flange.
Reference: "Oil Pump Installation: ".
Cylinder Head Installation - Right Side
Reference: "Cylinder Head Assemble: ".
Special tool
EN 46111 Crankshaft Rotation Socket
J 45059 Angle Meter
NOTE
Ensure that the crankshaft is in the timing
drive assembly position using the EN 46111.
1. Ensure the cylinder head locating pins are securely
mounted in the cylinder block deck face.
2. Install a NEW right cylinder head gasket using the
deck face locating pins for retention.
3. Align the right cylinder head with the deck face
locating pins.
4. Place the right cylinder head in position on the deck
face.
Engine Mechanical:
1D-263