Table of Contents
Advertisement
1J-49 Charging System:
Installation Procedure
1. Install the positive battery cable to the wire loom and
re-tape the loom.
2. Install the positive battery cable (4) lead to the starter
solenoid.
3. Install the positive battery cable to the engine wiring
harness clip (3).
CAUTION
!
Refer to "Fastener Notice: ".
4. Install the positive battery cable terminal to starter
solenoid nut (6).
Tightening torque
Tighten the nut to 10 N⋅m (89 lb in).
5. Lower the vehicle.
6. Connect the positive and negative battery cable clip
(3) to the battery tray support bracket.
7. Connect the positive and negative battery cable clip
to the side of the battery tray support bracket.
8. Install the battery box. Refer to "Battery Box
Replacement".
9. Install the positive battery cable terminal (2) to the
UBEC stud.
10. Install the positive battery cable terminal nut (1) to
the UBEC stud.
Tightening torque
Tighten the nut to 15 N⋅m (11 lb ft).
11. Install the UBEC cover.
12. Install the battery. Refer to "Battery Replacement".
Advertisement
Table of Contents
Troubleshooting
