Suzuki XL7 2007 Service Manual page 1155

Rear Differential Clutch Control Module
Calibration
After rear differential clutch control module (CCM)
replacement, the following calibration procedure must be
performed.
1. Install a scan tool.
2. Turn ON the ignition, with the engine OFF.
3. Select Special Functions, Rear Drive System, CCM
RDS Matching ID, follow instruction on the Tech 2.
The CCM RDS Matching ID number can be found on
the CCM harness connector.
Fastener Tightening Specifications - Rear Drive Axle
Clutch Drum Cover Bolts
Differential Clutch Control Module Screws
Differential Drain Plug
Differential Fill Plug
Differential Mounting Nuts
Differential Housing Support Bushing Bolts
Differential Side Cover Bolts
Left Rear Differential Mounting Bolts
Rear Axle Specifications
Gear Ratio 3.6L LZY
Rear Differential Fill Quantity
Sealers, Adhesives, and Lubricants
Differential Lubricant
Propeller Shaft Mounting Bolts
Specifications
Application
Application
Application
4. Cycle the ignition OFF, then start the engine and
allow to run for 1 minute. Verify the rear differential
system is functioning properly.
5. After the calibration procedure, clear all DTC, and
preform the "Diagnostic System Check - Vehicle
Diagnostic Information: ".
Rear Differential Clutch Control Module
Programming and Setup
CCM Replacement
If the rear differential clutch control module (CCM) is
replaced, the following procedures must be performed:
CCM Reprogramming—Refer to "Rear Differential
Clutch Control Module Calibration".
Specification
Metric
29 N⋅m
10 N⋅m
39 N⋅m
39 N⋅m
122 N⋅m
188 N⋅m
29 N⋅m
29 N⋅m
Metric
2.53
500 ml
Type of Material
Synthetic Gear Oil 75W-90
Threadlocker
Differential:
English
21 lb ft
89 lb in
29 lb in
29 lb ft
90 lb ft
139 lb ft
21 lb ft
21 lb ft
Specification
English
2.53
16.9oz
GM Part Number
89021677 (Canadian
P/N 89021678
89021297 (Canadian
P/N 10953488)
3B-26