Radiator Drain Cock Replacement; Draining And Filling Cooling System - Suzuki XL7 2007 Service Manual

1F-21 Engine Cooling System:

Radiator Drain Cock Replacement

Special tool
GE-47716 Vac N Fill Coolant Refill Tool
Removal Procedure
1. Drain the radiator. Refer to "Draining and Filling
Cooling System (LY7 GE 47716 Fill)" "Draining and
Filling Cooling System (LY7 Static Fill)".
2. Unscrew the drain plug from the radiator end tank.
3. Remove and discard the O-ring.
Installation Procedure
1. Install the new O-ring.
2. Install and tighten the drain plug into the end tank
drain hole.
3. Fill the radiator. Refer to "Draining and Filling
Cooling System (LY7 GE 47716 Fill)" "Draining and
Filling Cooling System (LY7 Static Fill)".
Repair Instructions
Draining and Filling Cooling System (LY7
GE 47716 Fill)
Special tool
• J 26568 Coolant and Battery Fluid Tester
• GE-47716 Vac N Fill Coolant Refill Tool
• J 42401 Radiator Pressure Adapter
Draining Procedure
!
In order to avoid personal injury, do not
remove the cap or open the cooling system
drains from a hot system. Allow the system
to cool first.
NOTE
A 7.6 liter (8 qt) coolant container will be
needed.
1. Place the coolant container under the radiator drain
cock located at the bottom of the right radiator end
tank.
2. Open the drain valve to start the flow of coolant.
Coolant will drain slowly until the surge tank cap is
removed.
WARNING