Table of Contents
Advertisement
3A-16 Drive Shaft:
NOTE
DO NOT re-use the wheel drive shaft spindle
nut. Replace with NEW.
5. Remove and discard the wheel drive shaft spindle
nut.
6. Using the J 42129, disengage the wheel drive shaft
from the wheel hub/bearing.
7. Remove the rear suspension knuckle. Refer to
"Knuckle Replacement: ".
8. Using a suitable tool, carefully release the wheel
drive shaft from the RDM (Rear Drive Module).
NOTE
Because of the design of the inner seal wheel
drive shaft seal, the seal will be removed at
the same time the wheel drive shaft is.
Replace the seal, DO NOT re-use the seal.
9. Remove the wheel drive shaft from the vehicle.
10. Remove the wheel drive seal.
Advertisement
Table of Contents
Troubleshooting
