Table of Contents
Advertisement
2C-11 Rear Suspension:
NOTE
Hold the ball shaft secure with a TORX® bit,
when installing the nut.
4. Install the stabilizer link to stabilizer shaft nut.
Tightening torque
Tighten the nut to 50 N⋅m (37 lb ft).
5. Install the rear suspension support. Refer to
"Support Replacement (AWD Vehicles)" "Support
Replacement (FWD Vehicles)".
6. Install the spare tire to the vehicle.
7. Lower the vehicle.
Rear Wheel Bearing and Hub Replacement
Removal Procedure
1. Raise and support the vehicle. Refer to "Lifting and
Jacking the Vehicle: ".
2. Remove the rear tire and wheel assembly. Refer to
"Tire and Wheel Removal and Installation: ".
3. Remove the brake rotor. Refer to "Rear Brake Rotor
Replacement: ".
4. Remove the wheel speed sensor. Refer to "Rear
Wheel Speed Sensor Replacement: ".
5. If equipped with all wheel drive (AWD), remove the
rear wheel driveshaft nut.
NOTE
The splash shield and park brake assembly
are supported to the knuckle between the
wheel bearing mounting bolts and the wheel
bearing. Care should be taken to support
these items while the wheel bearing is being
replaced.
6. Remove the 4 wheel bearing bolts.
Advertisement
Table of Contents
Troubleshooting
