Table of Contents
Advertisement
6. Remove the APP assembly from the vehicle.
Installation Procedure
1. Install the upper attachment bolt into the APP
assembly.
2. Install the APP assembly into the vehicle.
CAUTION
!
Refer to "Fastener Notice: ".
3. Install the remaining attachment bolts into the APP
assembly.
Tightening torque
Tighten the bolts to 25 N⋅m (18 lb ft).
Engine Electrical Devices:
4. Connect the APP sensor harness connector. Push
the connector in until the lock position is felt, then
pull back to confirm engagement.
5. Install the CPA to the APP sensor harness
connector.
6. Install the driver knee bolster. Refer to "Knee Bolster
Replacement: ".
7. Install the instrument panel left lower closeout panel.
Refer to "Instrument Panel Insulator Panel
Replacement - Left Side: ".
1C-19
Advertisement
Table of Contents
Troubleshooting
