Suzuki XL7 2007 Service Manual page 336

1C-30 Engine Electrical Devices:
2. Connect the engine wiring harness electrical
connector (2) to the bank 1 knock sensor.
3. Position the rear exhaust manifold heat shield to the
engine and install the bolts.
Tightening torque
Tighten the bolts to 50 N⋅m (37 lb ft).
4. Install the right catalytic converter. Refer to "Catalytic
Converter Replacement - Right Side: ".
5. Lower the vehicle.
Knock Sensor Replacement - Bank 2
Removal Procedure
1. Raise and suitably support the vehicle. Refer to
"Lifting and Jacking the Vehicle: ".
2. Disconnect the engine wiring harness electrical
connector (2) from the bank 2 knock sensor.
3. Loosen the knock sensor bolt and remove the knock
sensor.