2B-12 Front Suspension:
3. Remove the wheel speed sensor electrical
connector from the connector bracket.
4. Remove the front wheel drive shaft spindle nut.
5. Remove the speed sensor. Refer to "Front Wheel
Speed Sensor Replacement: ".
6. Support the wheel drive shaft with heavy mechanic's
wire or equivalent.
7. Remove and discard the wheel bearing/hub
mounting bolts.
8. Remove the wheel bearing/hub assembly from the
steering knuckle.
Installation Procedure
1. Install the wheel bearing/hub assembly to the
steering knuckle.
CAUTION
!
Refer to "Fastener Notice: ".
2. Install the wheel bearing/hub mounting bolts.
Tightening torque
Tighten the bolts to 130 N⋅m (96 lb ft).