Valve Lifter Installation - Right Side - Suzuki XL7 2007 Service Manual

Hide thumbs Also See for XL7 2007:

Table of Contents

1D-264 Engine Mechanical:

Refer to "Fastener Notice: ".

DO NOT allow oil on the cylinder head bolt

DO NOT reuse the old M11 cylinder head

5. Install new M11 cylinder head bolts.

Tightening torque

1. Tighten the M11 cylinder head bolts a first

pass in sequence to 45 N⋅m (33 lb ft).

2. Tighten the M11 cylinder head bolts a second

pass in sequence an additional 120 degrees

using the J 45059.

Reference: "Valve Lifter Installation - Right Side: ".

Valve Lifter Installation - Right Side

Reference: "Valve Lifters Cleaning and Inspection: ".

Do not stroke/cycle the stationary hydraulic

lash adjuster plunger without oil in the lower

pressure chamber.

Do not allow the stationary hydraulic lash

adjuster to tip over, plunger down, after the

1. Fill the stationary hydraulic lash adjuster (SHLA) with

clean engine oil GM P/N 12345610 (Canadian P/N

993193) or equivalent. Take precautions to prevent

scratching the pivot sphere area (1) of the SHLA.

2. Lubricate the SHLA bores in the cylinder head with

clean engine oil GM P/N 12345610 (Canadian P/N

993193) or equivalent.

3. Install the SHLAs in the cylinder head.