Suzuki XL7 2007 Service Manual page 1279

Step
1. Inspect each of the disc brake rotors for the following
surface and wear conditions:
Refer to "Brake Rotor Surface and Wear Inspection: ".
– Heavy rust and/or pitting
– Cracks and/or heat spots
– Excessive blueing discoloration
– Deep or excessive scoring beyond maximum
acceptable level
18
NOTE
Make the following determination AND ANSWER
the question INDIVIDUALLY for EACH rotor.
2. Make a determination for each brake rotor if the rotor
requires replacement based upon the results of the
inspection.
If the brake rotor exhibits any of the conditions listed
previously, it requires replacement.
Does the brake rotor require REPLACEMENT?
NOTE
Whenever a brake rotor is replaced, the assembled
lateral runout (LRO) of the rotor must be measured
to ensure optimum performance of the disc
19 brakes.
Replace the brake rotor. Refer to "Front Brake Rotor
Replacement" or "Rear Brake Rotor Replacement: ".
Did you complete the replacement?
NOTE
Perform the following inspection AND ANSWER
the question INDIVIDUALLY for EACH rotor.
Inspect each of the disc brake rotors for assembled lateral
20
runout (LRO) that exceeds the maximum acceptable level.
Refer to "Brake Rotor Assembled Lateral Runout
Measurement: ".
Does the brake rotor exhibit assembled LRO that exceeds the
maximum acceptable level?
Correct the LRO for each brake rotor that was determined to
have LRO exceeding the maximum acceptable level. Refer to
21
"Brake Rotor Assembled Lateral Runout Correction: ".
Did you complete the operation?
Install or connect components that were removed or
disconnected during diagnosis.
22
Did you complete the operation?
Action
Front Brakes:
Yes
Go to Step 19
Go to Step 22
Go to Step 21
Go to Step 22
Disc Brake System
OK
Return to Symptom
Table
4B-7
No
Go to Step 20
—
Go to Step 22
—
—