Suzuki XL7 2007 Service Manual page 301

6. Remove the caps from the fuel and EVAP lines.
7. Connect the fuel feed pipe quick connect fitting (2) to
the fuel tank. Refer to "Plastic Collar Quick Connect
Fitting Service: ".
8. Install the EVAP canister. Refer to "Evaporative
Emission Canister Replacement".
9. Lower the vehicle.
10. Connect the rear brake line fittings to the brake
pressure module.
Tightening torque
Tighten the fitting to 21 N⋅m (16 lb ft).
Aux. Emission Control Devices:
11. Remove the caps from the fuel and EVAP lines.
12. Connect the fuel feed pipe quick connect fitting (3) to
the fuel rail. Refer to "Metal Collar Quick Connect
Fitting Service: ".
13. Connect the EVAP pipe quick connect fitting (3) to
the EVAP purge solenoid. Refer to "Plastic Collar
Quick Connect Fitting Service: ".
14. Connect the negative battery cable. Refer to "Battery
Negative Cable Disconnection and Connection: ".
15. Bleed the hydraulic brake system. Refer to
"Hydraulic Brake System Bleeding (Pressure): "
"Hydraulic Brake System Bleeding (Manual): ".
16. Prime the fuel system.
a. Cycle the ignition ON for 5 seconds and then
OFF for 10 seconds. Repeat cycling twice.
b. Crank the engine until it starts. The maximum
starter motor cranking time is 20 seconds.
c. If the engine does not start, repeat the above
steps.
17. Run the engine and check the system for leaks.
1B-11