1D-78 Engine Mechanical:
6. Using engine support fixture, lower engine
approximately two inches.
7. Remove the crankshaft balancer bolt.
8. Install the J 38416-2 in the nose of the crankshaft.
9. Install the J 41816 in order to remove the crankshaft
balancer.
10. Tighten the center bolt of the J 41816 in order to pull
the crankshaft balancer off of the crankshaft.
11. Remove the J 41816 from the crankshaft balancer.
Installation Procedure
1. The EN 46106 must be installed onto the flywheel.
2. Use the J 41998-B, nut, bearing and washer to install
the crankshaft balancer.
NOTE
Do not lubricate the crankshaft front oil seal
or crankshaft balancer sealing surfaces. The
crankshaft balancer is installed into a dry
seal.
3. Apply lubricant to the inside of the crankshaft
balancer hub bore.