Valve Lifters Cleaning And Inspection - Suzuki XL7 2007 Service Manual

Hide thumbs Also See for XL7 2007:

Table of Contents

1D-190 Engine Mechanical:

5. Measure the camshaft thrust wall surface for runout

using J 7872. Refer to "Engine Mechanical

Specifications".

6. If the camshaft is damaged or worn beyond

specifications, replace the camshaft. No machining

of the camshaft is allowed.

7. Measure the camshaft lobes for wear using the J

8. Place the J 7872 with the indicator tip on the base

circle (1) of the camshaft lobe.

a. Place the J 7872 at zero.

b. Rotate the camshaft until the indicator tip is at

the highest point (3) on the lobe. This reading is

the lift of the camshaft lobe. Refer to "Engine

Mechanical Specifications".

c. If the indicated measurement is significantly

lower than these specifications, replace the

camshaft or engine performance will be reduced.

Reference: "Camshaft Installation - Right Side: ".

Reference: "Camshaft Installation - Left Side: ".

Valve Lifters Cleaning and Inspection

Reference: "Valve Lifter Removal - Left Side: ".

Reference: "Valve Lifter Removal - Right Side: ".

Refer to Valve Lifter Priming Notice.