Table of Contents
Advertisement
3B-19 Differential:
Drive Pinion Flange/Yoke and/or Oil Seal Replacement
Callout
Preliminary Procedures
1. Raise and support the vehicle. Refer to "Lifting and Jacking the Vehicle: ".
2. Remove the differential clutch drum assembly. Refer to "Rear Wheel Drive Module Clutch Housing
Replacement".
Differential Pinion Seal
Procedure
1. Install a sheet metal screw into the seal.
2. Attach a pair of pliers or a slider hammer to the screw and remove the seal.
3. Using the slide hammer or pliers, remove the seal.
1
4. Using the J 44636-1, install the pinion seal.
5. Inspect the fluid level. Refer to "Rear Axle Lubricant Level Inspection".
Tip: The pinion flange, the nut and the dust cover are NOT SERVICED separately. These items are
serviced with the differential clutch drum assembly.
Special Tools
J 44636-1 Front Output Shaft Seal Installer
4. Install the left rear support bolt.
5. Remove the transmission jack stand.
6. Install the right rear wheel drive shaft. Refer to "Rear
Wheel Drive Shaft Replacement: ".
7. Install the propeller shaft. Refer to "Propeller Shaft
Replacement: ".
8. Install the muffler assembly. Refer to "Muffler
Replacement: ".
9. Remove the spare tire.
10. Fill the rear differential with fluid. Refer to "Rear Axle
Lubricant Replacement".
Component Name
Advertisement
Table of Contents
Troubleshooting
