Suzuki XL7 2007 Service Manual page 1237

Jc636
Hide thumbs Also See for XL7 2007:
Table of Contents

Advertisement

Step
1. Inspect the following hydraulic brake system components
for external fluid leaks. Replace any of the components
found to be leaking brake fluid. Refer to the appropriate
procedures:
– "Master Cylinder Replacement"
Brake master cylinder reservoir cap diaphragm
– "Front Brake Hose Replacement"
– "Rear Brake Hose Replacement"
– "Brake Pipe Replacement"
– "Front Brake Caliper Replacement: "
– "Rear Brake Caliper Replacement: "
– "Brake Pressure Modulator Valve Replacement: "
6
2. If you repaired or replaced any of the brake system
components listed, bleed the hydraulic brake system.
Refer to "Hydraulic Brake System Bleeding (Pressure)"
"Hydraulic Brake System Bleeding (Manual)". While
bleeding the hydraulic brake system, observe for the
following conditions:
– The presence of air in the system at a bleeder valve
location other than at the repair location, except if the
brake master cylinder was replaced
– An unrestricted and even flow of brake fluid per axle
during the bleeding procedure
Did you find and correct a condition?
Was there air in the system at a bleeder valve location other
7
than at the repair location, except if the brake master cylinder
was replaced?
Was the flow of brake fluid unrestricted and even per axle
8
during the bleeding procedure?
Inspect the hydraulic function of the brake calipers/wheel
cylinders for proper operation. Refer to "Hydraulic Brake
9
Component Operation Visual Inspection: ".
Was the hydraulic function of the brake calipers/wheel
cylinders operating properly?
Was the flow of brake fluid restricted or uneven through front
10
axle hydraulic components during the bleeding procedure?
Was the flow of brake fluid restricted or uneven through rear
11
axle hydraulic components during the bleeding procedure?
Inspect the hydraulic function of the brake calipers/wheel
cylinders for proper operation. Refer to "Hydraulic Brake
12
Component Operation Visual Inspection: ".
Was the hydraulic function of the brake calipers/wheel
cylinders operating properly?
Action
Brake Control System and Diagnosis:
Yes
Go to Step 7
Go to Step 19
Go to Step 9
Go to Step 21
Go to Step 13
Go to Step 17
Go to Step 15
4A-18
No
Go to Step 12
Go to Step 8
Go to Step 10
Go to Step 14
Go to Step 11
Go to Step 13

Advertisement

Table of Contents
loading

Table of Contents