Suzuki XL7 2007 Service Manual page 300

1B-10 Aux. Emission Control Devices:
Installation Procedure
1. Install the EVAP feed pipe to the fuel/EVAP/brake
pipe assembly clips.
2. With the aid of an assistant, position and install the
fuel/EVAP/brake pipe clips (2) to the underbody
studs.
3. Install the push pin (1) to the underbody side rail
hole.
CAUTION
!
Refer to "Fastener Notice: ".
4. Connect the right rear brake line fitting to the rear
brake hose.
Tightening torque
Tighten the fitting to 18 N⋅m (13 lb ft).
5. Connect the left rear brake line fitting to the brake
crossover pipe.
Tightening torque
Tighten the fitting to 18 N⋅m (13 lb ft).