Engine Support Fixture Installation Procedure - Suzuki XL7 2007 Service Manual

Engine Support Fixture
Installation Procedure
Special tool
J 28467-B Universal Engine Support Fixture
J-28467-13 Engine Support Fixture Adapters
J 42451-1 Engine Support Adapter
J 36462-A Engine Support Adapter Leg Set
J 28467-7A Bolt Hook
J 28467-34 Lift Hook Wing Nut & Washer
1. Remove the fuel injector sight shield. Refer to "Fuel
Injector Sight Shield Replacement".
2. Pull each end of the hood rear seal away from the
cowl panel flange near both strut towers.
3. Install three J-28467-13 (1) and two J 28467-5 strut
tower adapters (2) to the top of the left and right strut
tower.
4. Install a 127 cm (50 in) engine support fixture cross
bar J-28467-B (3) transversely across the vehicle
between both J 28467-5 strut tower adapters (2).
5. Insert safety pins J-28467-10 (4) through the J
28467-5 strut tower adapters (2) and the cross bar
(3) to prevent movement.
Special Tools and Equipment
6. Install the engine support bracket J 42451-1 to the
engine.
CAUTION
!
Refer to "Fastener Notice: ".
7. Remove the alternator bolt (1), then install the
alternator bolt with the engine support bracket J
42451-1 to the engine.
Tightening torque
Tighten the bolts to 50 N⋅m (37 lb ft).
Engine Mechanical: 1D-365