Table of Contents
Advertisement
1C-28 Engine Electrical Devices:
Camshaft Position Actuator Solenoid Valve
Solenoid Replacement - Bank 2 (Left Side)
Exhaust
Removal Procedure
1. Remove the engine mount strut bracket. Refer to
"Engine Mount Strut Bracket Replacement - Right
Side: ".
2. Disconnect the engine wiring harness electrical
connector (7) from the bank 2 exhaust camshaft
position (CMP) actuator solenoid valve.
3. Remove the CMP actuator solenoid valve bolt.
4. Remove the CMP actuator solenoid valve.
5. Inspect the CMP actuator solenoid valve seal for
damage and replace as necessary.
Installation Procedure
1. Inspect the CMP actuator solenoid valve seal for
damage. Replace the seal if necessary.
2. Install the CMP actuator solenoid valve.
CAUTION
!
Refer to "Fastener Notice: ".
3. Install the CMP actuator solenoid valve bolt.
Tightening torque
Tighten the bolt to 10 N⋅m (89 lb in).
4. Connect the engine wiring harness electrical
connector (7) to the bank 2 exhaust CMP actuator
solenoid valve.
5. Install the engine mount strut bracket. Refer to
"Engine Mount Strut Bracket Replacement - Right
Side: ".
Advertisement
Table of Contents
Troubleshooting
