Suzuki XL7 2007 Service Manual page 436

1D-96 Engine Mechanical:
Installation Procedure
1. Ensure the crankshaft sprocket is installed with the
timing mark (1) visible.
2. Install the crankshaft sprocket on to the nose of the
crankshaft.
3. Align the notch in the crankshaft sprocket with the
pin in the crankshaft.
4. Slide the crankshaft sprocket on the crankshaft nose
until the crankshaft sprocket contacts the step in the
crankshaft.
5. Ensure the crankshaft is in the stage one timing
position with the crankshaft sprocket timing mark (1)
aligned to the stage one timing mark on the oil pump
cover (2) using the EN 46111. Refer to "Camshaft
Timing Drive Chain Alignment Diagram (Third
Design)" "Camshaft Timing Drive Chain Alignment
Diagram (Fourth Design)".
6. Install the primary camshaft timing chain. Refer to
"Primary Camshaft Drive Chain Installation (Third
Design)" "Primary Camshaft Drive Chain Installation
(Fourth Design)".
7. Install the primary upper camshaft drive chain guide.
Refer to "Primary Camshaft Drive Chain Guide
Installation - Upper (Third Design)" "Primary
Camshaft Drive Chain Guide Installation - Upper
(Fourth Design)".
8. Install the primary camshaft drive chain tensioner.
Refer to "Primary Camshaft Drive Chain Tensionser
Installation (Third Design)" "Primary Camshaft Drive
Chain Tensionser Installation (Fourth Design)".