Drive Belt Tensioner Replacement - Suzuki XL7 2007 Service Manual

Hide thumbs Also See for XL7 2007:

Table of Contents

Installation Procedure

1. Install the drive belt to the crankshaft pulley, the

tensioner and the generator.

2. Rotate the drive belt tensioner clockwise.

3. Install the drive belt to the idler pulley (1).

Ensure the drive belt is properly aligned and

seated into the grooves of the accessory

drive pulleys.

4. Slowly release the drive belt tensioner.

5. Raise the vehicle.

6. Install the right side engine mount bracket. Refer to

"Engine Mount Bracket Replacement - Right Side".

7. Install the engine splash shield. Refer to "Engine

Splash Shield Replacement - Right Side: ".

8. Lower the vehicle.

9. Install the engine mount strut bracket. Refer to

"Engine Mount Strut Bracket Replacement - Right

10. Remove the engine support fixture. Refer to "Engine

Support Fixture".

11. Install the air cleaner assembly. Refer to "Air Cleaner

Assembly Replacement".

Drive Belt Tensioner Replacement

Removal Procedure

1. Remove the drive belt. Refer to "Drive Belt

Replacement".

2. Loosen the idler pulley.

3. Remove the tensioner bolts.

4. Remove the tensioner.

Installation Procedure

1. Position the tensioner and install the tensioner bolts.

2. Tighten the idler pulley.

3. Install the drive belt. Refer to "Drive Belt

Replacement".

Engine Mechanical: