Suzuki XL7 2007 Service Manual page 545

Hide thumbs Also See for XL7 2007:

Table of Contents

3. Remove the water pump seal from the engine front

4. Discard the water pump seal.

Reference: "Engine Front Cover Cleaning and

Inspection: ".

Engine Front Cover Cleaning and

Reference: "Engine Front Cover Disassemble: ".

Special tool

J 28410 Gasket Remover

Cleaning Procedure

1. Remove any RTV sealant (1) from the engine front

cover using J 28410.

2. Clean out debris from the bolt holes.

3. Clean the engine front cover in solvent.

Refer to "Safety Glasses Caution: ".

4. Dry the engine front cover with compressed air.

Inspection Procedure

1. Inspect the exterior of the engine front cover for the

following conditions:

– Damage to the camshaft position actuator valve

oil seal bores (1)

– Damage to the engine front cover bolt holes (2)

– Damage and/or corrosion to the engine coolant

– Dents or damage to the exterior (4)

– Damage to the crankshaft front oil seal bore (5)

– Gouges or damage to the water pump sealing

surfaces (6)

– Damage to the water pump bolt hole threads (7)

2. Inspect the interior of the engine front cover for the

following conditions:

– Damage to the engine front cover bolt holes (1)

– Gouges or damage to the engine front cover

sealing surfaces to the engine block (7), oil pan

(5), and/or camshaft covers (2)

Engine Mechanical:

Troubleshooting