Primary Fuel Level Sensor Replacement Removal Procedure; Fuel Level Sensor Replacement - Secondary - Suzuki XL7 2007 Service Manual

1G-60 Fuel System:
Primary Fuel Level Sensor Replacement
Removal Procedure
NOTE
NEW fuel tank module seals are necessary
each time the fuel tank module is serviced.
Obtain NEW seals for both the primary and
secondary modules prior to beginning this
service procedure.
NOTE
There are 2 fuel level sender unit and float
assemblies in the fuel tank. There is 1 located
on each fuel pump module. The fuel level
sender unit and float is NOT the same for
each of the fuel pump modules.
1. Remove the fuel pump module. Refer to "Primary
Fuel Tank Module Replacement".
2. Disconnect the fuel level sender unit and float
electrical connector from the underside of the top of
the pump module.
3. Release the retaining tabs (1, 2) and remove the
level sensor by sliding up.
Installation Procedure
1. Install the fuel level sender unit and float onto the
fuel pump module. Make sure that the sender cap
snaps into place (1, 2).
2. Connect the fuel level sender unit and float electrical
connector.
3. Install the fuel pump module. Refer to "Primary Fuel
Tank Module Replacement".
Fuel Level Sensor Replacement -
Secondary
Removal Procedure
NOTE
A NEW fuel tank module seal is necessary
each time the fuel tank module is serviced.
Obtain a NEW seal prior to beginning this
service procedure.