Engine Front Cover Assemble - Suzuki XL7 2007 Service Manual

1D-206 Engine Mechanical:
– Gouges or damage to the water pump seal area
(3)
– Loose or damaged deadener plates (4)
– Damage and/or corrosion to the engine coolant
passage (6)
– Damage to the crankshaft front oil seal bore
– Gouges or damage to the O-ring sealing areas
3. Repair or replace the engine front cover as
necessary.
Reference: "Engine Front Cover Assemble: ".

Engine Front Cover Assemble

Reference: "Engine Front Cover Cleaning and
Inspection: ".
Special tool
EN 46103 Camshaft Actuator Valve Seal Remover/
Installer
J 29184 Output Shaft Seal Installer
NOTE
Do not lubricate the crankshaft front oil seal
or crankshaft balancer sealing surfaces. The
crankshaft balancer is installed into a dry
seal.
1. Install the NEW crankshaft front oil seal into the
engine front cover using the J 29184.
2. Place the seal into position with the notches (1) in
the seal down. The notches (1) will face in board
when properly installed.
3. Install the NEW camshaft position actuator valve oil
seals into the engine front cover using the EN
46103.
Reference: "Engine Front Cover Installation (Third
Design): ".
Reference: "Engine Front Cover Installation (Fourth
Design): ".