Suzuki XL7 2007 Service Manual page 1061

5. Install the coil springs. Refer to "Coil Spring
Replacement".
6. Install the adjustment links. Refer to "Adjustment
Link Replacement".
7. Install the trailing arms. Refer to "Trailing Arm
Replacement".
8. While holding the stabilizer link, install the stabilizer
link-to-lower control arm nut.
Tightening torque
Tighten the stabilizer link to lower control arm
nut to 15 N⋅m (11 lb ft).
CAUTION
!
Support the brake caliper with heavy
mechanic wire, or equivalent, whenever it is
separated from its mount and the hydraulic
flexible brake hose is still connected. Failure
to support the caliper in this manner will
cause the flexible brake hose to bear the
weight of the caliper, which may cause
damage to the brake hose and in turn may
cause a brake fluid leak.
9. Remove the supporting wire and position the brake
caliper and bracket assemblies back onto the
knuckles. Refer to "Rear Brake Caliper Bracket
Replacement: ".
10. Install the rear brake hose bracket nut and bolt.
Tightening torque
Tighten the rear brake hose bolt and nut to 12
N⋅m (106 lb in).
11. Position the wiring harness back to the original
location, connect the routing clips to the rear support
and upper control arms. Connect the rear wheel
speed sensor electrical connectors.
12. Connect the rear park brake cables through the
mounting brackets and onto the park brake
actuators.
13. Install the rear park brake cable routing bolts to the
trailing arms.
Tightening torque
Tighten the rear park brake cable routing bolt to
12 N⋅m (106 lb in).
14. Install the exhaust muffler. Refer to "Muffler
Replacement: ".
15. Install the tires and wheels. Refer to "Tire and Wheel
Removal and Installation: ".
16. Check the rear alignment. Refer to "Measuring
Wheel Alignment: ".
Rear Suspension: 2C-34