1D-6 Engine Mechanical:
• Use a pipe sealant bead of the size or quantity as
specified in the service procedure.
CAUTION
!
Do not allow the sealant to enter a blind hole.
The sealant may prevent the fastener from
achieving proper clamp load, cause
component damage when the fastener is
tightened, or lead to component failure.
Camshaft Timing Drive Chain Alignment Diagram (Third Design)
1. Intake Camshaft Position Actuator Left Side Timing Mark - Circle
2. Intake Camshaft Position Actuator Right Side Timing Mark - Triangle
3. Intake Camshaft Position Actuator Identifier
Schematic and Routing Diagram
Camshaft Position Actuator Timing Marks
• Apply the pipe sealant bead to the inside of any bolt
hole areas.
• Apply a continuous bead of pipe sealant to one
sealing surface.
NOTE
Do not overtighten the fasteners.
• Tighten the fasteners in sequence, if specified, and to
the proper torque specifications.
4. Exhaust Camshaft Position Actuator Identifier
5. Exhaust Camshaft Position Actuator Right Side Timing Mark - Triangle
6. Exhaust Camshaft Position Actuator Left Side Timing Mark - Circle