Table of Contents
Advertisement
12. Remove the lower control arm to support frame nut
and bolt.
13. Remove the lower control arm.
Installation Procedure
1. Inspect the coil spring upper and lower insulators, if
damage exists replace the insulators. Refer to "Coil
Spring Insulators Replacement".
2. Position the lower control arm to the support frame
and loosely install the nut and bolt.
3. Position the jackstand under the lower control arm.
4. Position the spring with the rubber insulators into the
vehicle.
5. Raise the jackstand to compress the spring.
CAUTION
!
Refer to "Fastener Notice: ".
6. Position the lower control arm to the knuckle and
install the nut and bolt.
Tightening torque
Tighten the lower control arm to knuckle bolt and
nut to 160 N⋅m (118 lb ft).
7. Tighten the lower control arm to support nut and bolt.
Tightening torque
Tighten the bolt to 110 N⋅m (81 lb ft).
Rear Suspension:
2C-16
Advertisement
Table of Contents
Troubleshooting
