Camshaft Position Sensor Replacement - Bank 2 (Left Side) Exhaust - Suzuki XL7 2007 Service Manual

Camshaft Position Sensor Replacement -
Bank 2 (Left Side) Exhaust
Removal Procedure
1. Remove the air cleaner assembly. Refer to "Air
Cleaner Assembly Replacement: ".
2. Disconnect the engine wiring harness electrical
connector (6) from the bank 2 exhaust camshaft
position (CMP) sensor.
3. Remove the CMP sensor bolt.
4. Remove the CMP sensor.
Engine Electrical Devices:
Installation Procedure
1. Install the CMP sensor.
CAUTION
!
Refer to "Fastener Notice: ".
2. Install the CMP sensor bolt.
Tightening torque
Tighten the bolt to 10 N⋅m (89 lb in).
3. Connect the engine wiring harness electrical
connector (6) to the bank 2 exhaust CMP sensor.
4. Install the air cleaner assembly. Refer to "Air Cleaner
Assembly Replacement: ".
1C-23