Table of Contents
Advertisement
14. Connect the left and right cylinder head engine
electrical wiring harness to the following
components:
– Camshaft position actuators (2)
– Camshaft position sensors (1)
15. Connect the engine electrical wiring harness to the
following components:
– Install wire harness to retainers (5, 6, 8, 9)
– Ground leads (7, 11)
– Ignition coils (3, 4, 10)
– EVAP purge solenoid (2)
– Oxygen sensor (1)
16. Connect the wiring harness retaining clips near the
right and left shock towers.
17. Install NEW frame-to-body bolts.
Tightening torque
Tighten the bolts to 155 N⋅m (114 lb ft).
18. Install the drivetrain and front suspension frame
reinforcement. Refer to "Drivetrain and Front
Suspension Frame Reinforcement Replacement: ".
19. Raise the vehicle up away from the frame support
fixture or jackstands and remove the support fixture
or jackstands from under the vehicle.
20. Lower the vehicle.
21. Install the bolts (2) that secure the right engine
mount (1) to the engine (3).
Tightening torque
Tighten the bolts to 50 N⋅m (37 lb ft).
22. Raise the vehicle.
Engine Mechanical:
1D-127
Advertisement
Table of Contents
Troubleshooting
