Table of Contents
Advertisement
Lower Intake Manifold Replacement
Removal Procedure
1. Remove the fuel injectors and fuel rail. Refer to "Fuel
Injector and Fuel Rail Replacement: ".
2. Remove the lower intake manifold bolts (1).
3. Remove the lower intake manifold and gasket from
engine. Discard the gasket.
4. Clean and inspect the intake manifold and the
sealing surfaces. Refer to "Intake Manifold Cleaning
and Inspection".
Installation Procedure
1. Install the lower intake manifold gasket.
2. Install the lower intake manifold bolts (1).
CAUTION
!
Refer to "Fastener Notice: ".
3. Install the fuel injectors and fuel rail. Refer to "Fuel
Injector and Fuel Rail Replacement: ".
Tightening torque
Tighten the bolts to 23 N⋅m (17 lb ft).
Crankshaft Balancer Replacement
Special tool
EN 46106 Flywheel Holding Tool
J 38416-2 Crankshaft Button
J 41816 Crankshaft Balancer Remover
J 45059 Angle Meter
Removal Procedure
1. Install the engine support fixture. Refer to "Engine
Support Fixture".
2. Remove the engine mount strut bracket. Refer to
"Engine Mount Strut Bracket Replacement - Right
Side".
3. Remove the engine mount. Refer to "Engine Mount
Replacement - Right Side".
4. Remove the starter. Refer to "Starter Removal: ".
5. Install the EN 46106 through the starter mounting
hole.
Engine Mechanical:
1D-77
Advertisement
Table of Contents
Troubleshooting
