Suzuki XL7 2007 Service Manual page 458

1D-118 Engine Mechanical:
Installation Procedure
1. If necessary, perform the following steps:
– Assemble the cylinder head. Refer to "Cylinder
Head Assemble".
– Install the camshaft. Refer to "Camshaft
Installation - Left Side".
– Install the exhaust manifold to the cylinder head.
Refer to "Exhaust Manifold Installation - Left Side:
".
2. Install a NEW cylinder head gasket.
3. Carefully install the cylinder head with the exhaust
manifold to the engine. Refer to "Cylinder Head
Installation - Left Side".
4. Install the catalytic converter to the exhaust
manifold. Refer to "Catalytic Converter Replacement
- Left Side: ".
5. Connect the wiring harness electrical connector
located at the side of the cylinder head.
CAUTION
!
Refer to "Fastener Notice: ".
6. Install the wiring harness ground to the cylinder
head.
Tightening torque
Tighten the wiring harness ground bolt to 10 N⋅m
(89 lb in).
7. Install the coolant temperature sensor electrical
connector.
8. Install the oil level indicator. Refer to "Oil Level
Indicator and Tube Replacement: ".
9. Install the left bank secondary timing chain. Refer to
"Secondary Camshaft Drive Chain Replacement -
Left Side".
Cylinder Head Replacement - Right Side
Removal Procedure
1. Remove the engine. Refer to "Engine Replacement".
2. Remove the right bank secondary timing chain.
Refer to "Secondary Camshaft Drive Chain
Replacement - Right Side".