Suzuki XL7 2007 Service Manual page 856

1G-56 Fuel System:
Installation Procedure
1. Install the fuel tank pressure sensor to the fuel pump
module assembly. Ensure that the sensor grommet
is fully seated to the pump module.
2. Connect the pump module electrical connector to the
fuel tank pressure sensor.
3. Install the fuel tank. Refer to "Fuel Tank
Replacement (FWD)" "Fuel Tank Replacement
(AWD)".
Primary Fuel Tank Module Replacement
Special tool
J 45722 Fuel Sender Lock Ring Wrench
Removal Procedure
NOTE
NEW fuel tank module seals are necessary
each time the fuel tank module is serviced.
Obtain NEW seals for both the primary and
secondary modules prior to beginning this
service procedure.
WARNING
!
Whenever fuel line fittings are loosened or
removed, wrap a shop cloth around the fitting
and have an approved container available to
collect any fuel.
CAUTION
!
Clean all fuel pipe and hose connections and
surrounding areas before disassembling to
avoid possible contamination of the fuel
system. Spray the fuel pump module cam-
lock ring tang with penetrating oil prior to
attempting removal.
1. Remove the fuel tank. Refer to "Fuel Tank
Replacement (FWD)" "Fuel Tank Replacement
(AWD)".
2. Disconnect the electrical connectors from the
primary fuel pump module (1) and fuel tank pressure
sensor.