Fuel Feed Pipe Replacement Removal Procedure - Suzuki XL7 2007 Service Manual

3. Once installed, pull on both sides of the quick-
connect fitting in order to make sure the connection
is secure.
Fuel Feed Pipe Replacement
Removal Procedure
WARNING
!
Do not allow smoking or the use of open
flames in the area where work on the fuel or
EVAP system is taking place. Anytime work is
being done on the fuel system, disconnect
the negative battery cable, except for those
tests where battery voltage is required.
WARNING
!
Refer to "Gasoline/Gasoline Vapors Caution:
" in Cautions and Notices.
WARNING
!
Whenever fuel lines are removed, catch fuel
in an approved container. Container opening
must be a minimum of 300 mm (12 in)
diameter to adequately catch the fluid.
CAUTION
!
Fuel/Vapor lines cannot be spliced or
repaired. The line must be replaced (if
damaged) with the same type of line.
1. Disconnect the negative battery cable. Refer to
"Battery Negative Cable Disconnection and
Connection: ".
2. Disconnect the fuel feed pipe quick connect fitting (3)
from the fuel rail. Refer to "Metal Collar Quick
Connect Fitting Service".
3. Disconnect the evaporative emission (EVAP) pipe
quick connect fitting (3) from the EVAP purge
solenoid. Refer to "Plastic Collar Quick Connect
Fitting Service".
4. Cap the fuel and EVAP lines in order to prevent
system contamination.
5. Disconnect the rear brake line fittings from the brake
pressure module.
6. Raise and support the vehicle. Refer to "Lifting and
Jacking the Vehicle: ".
7. Remove the EVAP canister. Refer to "Evaporative
Emission Canister Replacement: ".
Fuel System: 1G-39