Suzuki XL7 2007 Service Manual page 1145

Differential Carrier Cover and Seal Replacement - Left Side
Callout
Preliminary Procedure
Remove the rear differential assembly. Refer to "Differential Replacement".
Differential Side Cover Bolts (Qty: 8)
CAUTION
!
Refer to "Fastener Notice: ".
1
Tip: Finger tighten the bolts before torquing to specification.
Tightening torque
Tighten the bolts in a criss cross pattern to 29 N⋅m (21 lb ft).
Differential Side Cover
2
Tip: Inspect the differential side cover for any damage. If the side cover is damaged, replace the
differential assembly. The side cover is not serviced separately.
Differential Side Cover Seal
Tip:
3
1. Before installing the side cover seal, ensure that the groove for the side cover seal is free of dirt
and debris. This will ensure that the seal seat properly in the differential housing.
2. Apply a small amount of clean oil to the side cover seal.
Rear Axle Shaft Seal Replacement - Left
Side
Special Tools
1. J 8092 Driver Handle
2. J 33832 Rear Bearing Installer
Removal Procedure
1. Raise and support the vehicle. Refer to "Lifting and
Jacking the Vehicle: ".
2. Drain the rear differential. Refer to "Rear Axle
Lubricant Replacement".
3. Remove the muffler assembly. Refer to "Muffler
Replacement: ".
Component Name
4. Remove the spare tire.
NOTE
In the following service procedure, it is not
necessary to completely remove the
propeller shaft. Relocate the propeller shaft
to the side and secure with mechanics wire
or equivalent.
5. Remove the propeller shaft. Refer to "Propeller Shaft
Replacement: ".
6. Remove the left rear wheel drive shaft. Refer to
"Rear Wheel Drive Shaft Replacement: ".
7. Support rear differential with a transmission jack
stand.
Differential: 3B-16