1G-34 Fuel System:
Removal Procedure
1. Relieve the fuel system pressure, if required.
Perform the following steps:
WARNING
!
Wrap a shop towel around the fuel pressure
connection in order to reduce the risk of fire
and personal injury. The towel will absorb
any fuel leakage that occurs during the
connection of the fuel pressure gage. Place
the towel in an approved container when the
connection of the fuel pressure gage is
complete.
a. Wrap a shop towel around the fuel rail service
port.
b. Place the hose on the J 34730-1A into an
approved gasoline container.
c. Open the valve on the J 34730-1A in order to
bleed any fuel from the fuel rail.
d. Close the valve on the J 34730-1A.
e. Remove the hose on the J 34730-1A from the
approved gasoline container.
f.
Remove the shop towel from around the fuel rail
service port, and place in an approved gasoline
container.
CAUTION
!
Clean all of the following areas before
performing any disconnections in order to
avoid possible contamination in the system:
• The fuel pipe connections
• The hose connections
• The areas surrounding the connections
2. Disconnect the J 34730-1A from the fuel rail service
port.
3. Install the fuel rail service port cap.
4. Tighten the fuel fill cap.
Metal Collar Quick Connect Fitting Service
Special tool
J 37088-A Fuel Line Disconnect Tool Set
Removal Procedure
WARNING
!
Refer to "Gasoline/Gasoline Vapors Caution:
".
1. Relieve the fuel system pressure. Refer to the "Fuel
Pressure Relief (With J 34730-1A)" "Fuel Pressure
Relief (Without J 34730-1A)".
2. Remove the fuel feed line quick connect fitting
retainer.