1G-36 Fuel System:
2. Push both sides of the fitting together in order to
snap the retaining tabs into place.
3. Once installed, pull on both sides of the fitting in
order to make sure the connection is secure.
4. Install the retainer to the quick-connect fitting.
Plastic Collar Quick Connect Fitting Service
Removal Procedure
WARNING
!
Refer to "Gasoline/Gasoline Vapors Caution:
".
NOTE
There are several types of plastic collar fuel
and evaporative emission quick connect
fittings used on this vehicle.
• Bartholomew (1)
• Q Release (2)
• Squeeze to Release (3)
• Sliding Retainer (4)
The following instructions apply to all of
these types of plastic collar quick connect
fittings except where indicated.
1. Relieve the fuel system pressure. Refer to the "Fuel
Pressure Relief (With J 34730-1A)" "Fuel Pressure
Relief (Without J 34730-1A)".