3. Connect the engine harness electrical connector to
the starter.
4. Install the starter solenoid BAT terminal nut.
Tightening torque
Tighten the bolts/nuts to 13 N⋅m (115 lb in).
5. Install the front catalytic convertor. Refer to "Catalytic
Converter Replacement - Left Side: ".
6. Lower the vehicle.
7. Connect the negative battery cable. Refer to "Battery
Negative Cable Disconnection and Connection: ".
Starter Removal
Reference: "Drive Belt Tensioner Removal: ".
1. Remove the starter motor bolts.
2. Remove the starter motor.
Starting System:
1I-19