Table of Contents
Advertisement
1D-262 Engine Mechanical:
2. Install the EN-47839 with the J 42183 (1, 2) onto the
rear of the crankshaft flange.
3. Place a 3 mm (0.118 in) bead of RTV sealant, GM P/
N 12378521 (Canadian P/N 88901148) or
equivalent, to the NEW crankshaft rear oil seal
housing as shown (1).
NOTE
DO NOT allow any engine oil on the area
where the crankshaft rear oil seal housing is
to be installed.
4. Install the crankshaft rear oil seal housing to the
engine block.
5. Remove the EN 46109 6 mm (0.236 in) guides from
the engine block.
Advertisement
Table of Contents
Troubleshooting
