Table of Contents
Advertisement
1D-274 Engine Mechanical:
4. Ensure the proper timing mark is used. Observe the
outer ring of the camshaft position actuator for the
triangle marking (2). The triangle marking is for
alignment to the highlighted timing chain link on the
right side of the engine.
CAUTION
!
Refer to "Torque Reaction Against Timing
Drive Chain Notice".
5. Use an open wrench on the hex cast into the
camshaft in order to prevent camshaft rotation when
tightening the camshaft position actuator bolt.
6. Install the right intake camshaft position actuator.
CAUTION
!
Refer to "Fastener Notice: ".
7. Install the camshaft position actuator bolt.
Tightening torque
Tighten the camshaft position actuator bolt to 58
N⋅m (43 lb ft).
Reference: "Camshaft Position Actuator Installation -
Right Side Exhaust (Fourth Design): ".
Camshaft Position Actuator Installation -
Right Side Exhaust (Third Design)
1. Ensure the proper camshaft position actuator is
installed. Observe the body of the camshaft position
actuator for the "EX" marking (1). The marking is for
an exhaust camshaft position actuator.
2. Ensure the proper timing mark is used. Observe the
outer ring of the camshaft position actuator for the
triangle marking (2). The marking is for alignment to
the highlighted timing chain link on the right side of
the engine.
CAUTION
!
Refer to "Torque Reaction Against Timing
Drive Chain Notice".
3. Use an open wrench on the hex cast into the
camshaft in order to prevent camshaft rotation when
tightening the camshaft position actuator bolt.
Advertisement
Table of Contents
Troubleshooting
