Suzuki XL7 2007 Service Manual page 449

NOTE
Ensure that the camshaft timing chain and
the camshaft position actuators are marked
for proper assembly.
9. Mark the timing chain and the respective locations
on camshaft position actuators (15-18).
10. Remove the camshaft position actuator bolt.
11. Remove the camshaft bearing caps and the
camshaft. Refer to "Camshaft Removal - Right Side".
Installation Procedure
NOTE
• Ensure that the marks on the camshaft
position actuators and the timing chain
(15-18) are aligned.
• DO NOT tighten the camshaft position
actuator bolt at this time.
1. Locate the camshafts to the cylinder head and
assemble the camshaft actuators to the camshafts.
2. Install the camshafts and the camshaft bearing caps.
Refer to"Camshaft Installation - Right Side".
3. Remove the EN 46108.
4. Install the crankshaft balancer. Refer to "Crankshaft
Balancer Installation".
CAUTION
!
Refer to "Torque Reaction Against Timing
Drive Chain Notice".
NOTE
Use an open-end wrench at the camshaft hex
to prevent camshaft/engine rotation.
5. Install and tighten the camshaft position actuators.
Refer to"Camshaft Position Actuator Installation -
Right Side Intake (Third Design)" "Camshaft Position
Actuator Installation - Right Side Intake (Fourth
Design)" and "Camshaft Position Actuator
Installation - Right Side Exhaust (Third Design)"
"Camshaft Position Actuator Installation - Right Side
Exhaust (Fourth Design)".
6. Install the intake camshaft position actuator solenoid.
Refer to "Camshaft Position Actuator Solenoid Valve
Solenoid Replacement - Bank 1 (Right Side) Intake:
".
7. Install the camshaft sensors. Refer to "Camshaft
Position Sensor Replacement - Bank 1 (Right Side)
Exhaust: " and "Camshaft Position Sensor
Replacement - Bank 1 (Right Side) Intake: ".
8. Install the camshaft cover. Refer to "Camshaft Cover
Replacement - Right Side".
9. Install the lower intake manifold. Refer to "Lower
Intake Manifold Replacement".
Engine Mechanical: 1D-109