Table of Contents
Advertisement
33. Lower the vehicle.
34. Remove the bolts (2) that secure the right engine
mount (1) to the engine (3).
NOTE
Insure the vehicle body is secured to the
hoist.
35. Raise the vehicle.
36. Place a universal frame support fixture or jackstands
under the frame.
37. Lower the vehicle until the frame contacts the frame
support fixture or jackstands.
38. Disconnect the wiring harness retaining clips near
the right and left shock towers.
39. Remove the drivetrain and front suspension frame
reinforcement. Refer to "Drivetrain and Front
Suspension Frame Reinforcement Replacement: ".
40. Remove the frame-to-body bolts. Discard the bolts.
NOTE
Inspect for areas of body to powertrain
contact or entanglement of wires and hoses
while separating the vehicle body and
powertrain.
41. Carefully raise the vehicle body up away from the
powertrain.
42. Disconnect the engine electrical wiring harness from
the following components:
– Oxygen sensor (1)
– EVAP purge solenoid (2)
– Ignition coils (3, 4, 10)
– Ground leads (7, 11)
– Remove wire harness from retainers (5, 6, 8, 9)
43. Disconnect the left and right cylinder head engine
electrical wiring harness from the following
components:
– Camshaft position sensors (1)
– Camshaft position actuators (2)
Engine Mechanical:
1D-123
Advertisement
Table of Contents
Troubleshooting
