Suzuki XL7 2007 Service Manual page 940

1J-47 Charging System:
Installation Procedure
1. Install the negative battery cable to the wiring loom
and re-tape the loom.
2. Install the negative battery cable ground terminal (1)
to the transaxle stud.
CAUTION
!
Refer to "Fastener Notice: ".
3. Install the negative battery cable ground terminal nut
(2) to the transaxle stud.
Tightening torque
Tighten the nut to 45 N⋅m (33 lb ft).
4. Install the negative battery cable ground terminal to
the wheelhouse stud.
5. Install the negative battery cable ground terminal nut
to the wheelhouse stud.
Tightening torque
Tighten the nut to 12 N⋅m (106 lb in).
6. Connect the body wiring harness electrical
connector (4) to the battery current sensor (5).
7. Connect the negative battery cable electrical
connector (7) to the body wiring harness electrical
connector (2).
8. Connect the positive and negative battery cable clip
(3) to the battery tray support bracket.
9. Connect the positive and negative battery cable clip
to the side of the battery tray support bracket.
10. Install the battery box. Refer to "Battery Box
Replacement".