Chrysler Conquest 1988 Service Manual page 743

ENGINE - Cvlinder Head
9-43
Identification mark.
- Timing chain side
5EN06f
@ Timing chain side
5ENOiE
(3) Be sure to position the gasket on the cylinder block with
the identification mark up.
Identification mark: "54"
(4) Install aligning with the dowel pin on the cylinder block
top surface. -
Caution
Do not apply sealant to cylinder head gaskdt.
_
2. INSTALLATION OF BOLT / 1. CYLINDER HEAD BOLT
Install cylinder head bplts. Starting at top center, tighten all
cylinder head bolts to l/2 of specified torque in sequence
shown in illustration.
._
.
..-.- -_- ._