Chrysler Conquest 1988 Service Manual page 1007

LUBRICATION AND MAINTENANCE
- Maintenance Service
(1) Use filter wrench or the like to remove oil filter.
(2) Apply a thin film of engine oil to the surface of gasket
before screwing filter on.
(3) Then tighten filter enough by hand.
(4) Start and run engine and check for engine oil leaks.
(5) After stopping engine, check oil level and refill as neces-
sary.
VALVE CLEARANCE (Check and adjust as re-
quired)
NOOSACH
Incorrect valve clearances will not only result in unsteady
engine operation, but will also cause excessive noise and
reduced engine output.
Check the valve clearances and adjust as required while the
engine is hot.
Valve-to-rocker arm clearances:
Jet valves
0.25 mm (.OlO in.)
VALVE CLEARANCE ADJUSTMENT
INTAKE AND EXHAUST VALVES
The auto-lash adjuster is installed to the rocker arm so that the
valve clearance adjustment is maintenance-free.
For additional 'information regarding the auto-lash adjuster,
refer to GROUP 9 ENGINE.
JET VALVE
Caution
The cylinder head bolts should be retightened before
attempting this adjustment.
(1) Warm up the engine until the engine coolant is heated to 85
to 95°C (185 to 205°F).
(2) Remove all spark plugs from the cylinder head- for easy
operation.
(3) Remove the air intake pipe.
(4) Remove the rocker cover.