Chrysler Conquest 1988 Service Manual page 1068

REAR AXLE -
Differential Carrier
Spring plate
-I~
llS671
llS66f
(7) Place parts in the drtferentral case (BJ In the illustrated .-
direction.
NOTE
(a) Before assembly, apply the specified gear oil to 1
each component being especially careful to coat all
I
contact surfaces and sliding surfaces.
_
Specified gear oil:
MOPAR Hypoid Gear Lubricant Part No.
4318058 plus MOPAR Hypoid Gear Oil Addi-
tive - Friction Modifier, Part No. 4318060 or
equivalent
(b) Be careful not to Insert the trrction plates and tnction
discs rn the Incorrect order and to rnstall the spring 1
plates and spring discs in Incorrect direction, iy
l
CLUTCH PLATE PRELOAD ADJUSTMENT
(1) Align mating marks (same numeral on each case) on . ..-
differential case (A) and differential caz (B),
(2) Tighten screws with a screwdriver in several steps until
the cases-are brought into close contact.
.-I
NOTE
If end faces of cases (A) and (B) do not come into close _
contact when screws are tightened, incorrect engage- 2
ment of preload spring and outer clutch plate or sprk-rg or
plate with groove is suspected. Assemble again.
(3) After assembly, in order to check the frictronal.force of -'_"
the clutch plate, use the special tools to measure the -1
starting
torque.
NO-j-E --~
Slightly rotate the unit before measuring the
torque. '
Standard value:
When a new clutch plate is used
50 - 80 Nm (36 - 58 ft.lbs.)
When an old clutch plate is used
35 - 80 Nm (25 - 58 ft.lbs.)